Outside Pics

Here are a few shots of the trim that I just put on. Not perfect, but original! The top and bottom are quite different on purpose. "Bug-eye" man needs some trimming to make him fit under the canopy. I will save that for another day.

The Long Awaited Update

As you can see, I have done quite a bit in the last couple of weeks. The covering is done and the trim work is beginning. I am very happy with the underside! I wanted a very HUGE contrast and I think I succeeded. The tail stripes are leftover trimmings from the wing pieces. They had such a cool shape that I had to use them somehow. I don't think that I could have cut them like that on purpose. I am debating if I should add 1/4" black stripes on each side of the green, I think it might give it a more finished appearance.

The top, on the other hand, will be completely different. I will have to wait to do it because Tower Hobbies sent me the wrong stuff and I just realized it. You will have to wait and see what this twisted mind comes up with.

Check out my NEW pilot! Bee Man was too small and not vi sable enough so he got bumped for this fine looking fellow. He reminds me of what all Jr. High teachers feel on the inside!!!!

Yes...I Suck.

Well I have done quite a bit except post my progress. The tank is in and the plumbing is done. The cowl turned out better than I thought-not perfect-but OK. If it explodes into two pieces, I will order a fiberglass one and be done with it. I have the belly pan on and the covering has begun. I am trying to do a better job than on the last plane.

Teaser Spy Photos!

Here is some pics of everything put together. I just couldn't stand it, I had to do it. The tail blocks are back on and I think it is in line with the fuse. Everything comes back apart and now I will begin building the wind attachment stuff.

Setbacks, Setbacks

Well, I finally got a little done. One of my novice mistakes was to make a bannana fuse. The tail was about 1/8" off to one side! I decided to hack the tail blocks off and add a little wood to make the rear end match the plans. Here are some pics of the fuel tank and its Rube Goldberg fuel line routing. I have also installed the EZ fueler and the front sheeting. I put a small piece of monokote around the fueler so that it will be eaiser to cover that area later. The servo rails are now in place and they seem to line up with the pushrods well.

Tail Work

Brrrr......It's too cold in the garage to do much. I glued the blocks on the rear and then shaped them to match the rest of the fuse. The tail is just in place to see if it fits. I am still trying to decide about the motor placement. I have noticed that the fuse has a twist in it. I don't really know what is up, but I'm not crazy about being outside when it is so cold. Oh well, I guess that is what makes building so interesting.

Give me some skin, man!

Here is the progress this afternoon. I have sheeted the turtle deck but decided to wait on the front portion until I decide what to do with the engine mounting. My choices:

1. Mount the engine upside down with the tank in place and hope for the best.

2. Leave the tank in place and mount the engine sideways (probably what I'll do).

3. Try to move the tank lower and mount the engine upside down.

If I mount the engine sideways, I might be able to use swap the position of the pushrods, but that will be another day.